How To Change A Bathtub Faucet

Wiggle the handle and pull it off. Install the new nipple Wrap both ends of the new nipple with thread tape and screw it into the fitting inside the wall.

How To Replace A Bathtub Spout Diy Family Handyman

Place a socket wrench over the bathtub faucet stem until it covers the hex nut.

How to change a bathtub faucet. Having detached the faucet lift rod use an adjustable wrench to unscrew the slip nut on the bending P-trap pipe under the sink. Many bathroom faucets come with a gasket you can install on the bottom of the assembly. Replace the aerator and youre done installing your new bathroom faucet.

Unscrew any remaining elements at the base of the faucet with your screwdriver. Do this first then check to see whether your model needs sealant or plumbers putty. Repeat the steps if you have a two-handle system.

You may need to slide a putty knife underneath the spout to loosen the putty first. Now you should disconnect the entire stem from the bathtubs water pipes. TheHomeDepot HomeImprovement DIYSUBSCRIBE to The Home Depot.

Repeat this same process with the handles. Just remove the aerator. Hold the plate against the wall for approximately one or two minutes applying firm and even pressure.

Apply plumbers putty to the back of the escutcheon plate. Its a good idea to flush the new faucet and check for leaks before youre done. Unscrew the whole stem from pipes.

Turn the wrench counterclockwise to loosen the nut until you can pull the stem free. Check all the connections and retighten if needed. Wipe away any excess putty that may be left over from this process.

But its not just the cosmetics that make it worth the switch. Then pull straight up on the spout to remove it andor unscrew any remaining base elements. If your bathtub faucet has seen better days it may not be diverting the water to the shower-head properly.

Locat the rings on the coutnertop that help keep the faucet. If your bathtub faucet has started to look bad then it may be time to invest in a new one. Then run hot and cold water for one minute.

Put the plate back on to the shower arm and slide the plate up against the wall and press firmly. Httpyoutube1ARJpksmNIw How To Remove Bathtub Faucet Stems Quick And Easy. Loosen the screw located on the back of the spouts base with a hex key.

The set screw may be in the back like the faucet or at the very top of the handle. Many brands like the Moen Roman tub faucet will follow a similar removal procedure. You may need to slip a putty knife between the base of the faucet and tub deck if its been caulked or sealed.

Looking for a quick and easy faucet repair in the bathtub and the quick home m. Remove and replace the stem handles spout replacing a bathtub faucet is a pretty simple process. Learn how to replace a bathtub faucet with our helpful guide.

You may need a faucet handle puller if the handle will not come off by hand. The valve mechanism varies according to the brand and model of the faucet. In order to reduce the amount of time it actually takes to replace the faucet lets do the followiing.

Replacing the spout in your bathtub can give your bathroom a brighter fresher look. Bathtub spouts can go bad in three ways. First the tub spout diverter can wear out so it no longer blocks the water flow and sends water to the shower head.

Remove the stem out of the faucet with caution. Apply either as directed and create a tight seal all the way around. Seal around it with silicone caulk and screw on the new spout.

Many bathroom faucet replacement kits include new drains so take this opportunity to replace the drain pipe.

How To Replace A Bathtub Faucet The Home Depot